Engine Oil. TOHATSU BFT 115A, BFT 150A
advertisement
36ZX1T120_EN.book Page 110 Tuesday, November 28, 2017 4:48 PM
STORAGE
FRONT BRACKET CLAMP
DRAIN TUBE
DRAIN SCREW
VAPOR SEPARATOR
1. Remove the engine cover.
2. Unhook the drain tube from the front bracket clamp.
3. Set the end of the tube toward the outside of the engine undercase.
Draining the fuel becomes easier when the front end of the drain tube is as low as possible.
4. Loosen the vapor separator drain screw.
110
5. Tilt up the outboard motor.
6. When the gasoline starts to flow out of the drain tube, tilt up the outboard motor and hold it in the position until the gasoline stops flowing. After draining the gasoline completely, return the outboard motor to the vertical position.
7. After draining thoroughly, tighten the drain screw securely.
8. Clamp the drain tube on the front bracket clamp.
Engine Oil
1. Change the engine oil (see page
87).
2. Remove the spark plugs (see page
89), and remove the clip from the emergency stop switch.
3. Pour 1 – 2 teaspoons (5 – 10 cm of clean engine oil into the cylinder.
3 )
4. Rotate the engine a few revolutions to distribute the oil in the cylinders.
5. Reinstall the spark plugs (see page
92).
advertisement