Mounting the universal shaft on the machine. Krone BA EasyCut B 970

Add to My manuals
110 Pages

advertisement

Mounting the universal shaft on the machine. Krone BA EasyCut B 970 | Manualzz

6

6.2

6.2

Initial operation

Mounting the universal shaft on the machine

Mounting the universal shaft on the machine

1 2

3

6.3

KMG000-053

ü

The machine has been shut down and secured, see Page 25

.

„ Unscrew the screw (1) on the universal shaft guard (2).

„ Turn protective cap and protective pipe towards each other and push back universal shaft guard (2) in the direction of the arrow.

„ Push the universal shaft with overload protection onto the PTO shaft on the mower. Ensure that the safety device (3) has engaged.

„ Remount universal shaft guard (2) and secure with screw (1).

„ Push universal shaft guard (2) onto the gearbox extension and secure with the auger thread clamp.

INFO

More details can be found in the operating instructions for the universal shaft.

Adapting Coupling Points

46

KMG000-033

Lower link pin

The three-point linkage is designed for category II and III.

The machine has been prepared at the factory for category II.

„ Mount a ball sleeve category II (1) inside on the lower link pins (2).

„ Secure the lower link pins (2) with the linch pin (4) and the safety chain (5).

EasyCut B 970

Original operating instructions 150000711_04_us

Initial operation

Adapting Coupling Points

Conversion to category III

„ Pull out the lower link pins (2).

„ Mount a ball sleeve category III (1) outside on the lower link pins (2).

„ Secure the lower link pins (2) with the linch pin (4) and the safety chain (5).

6

6.3

Top link pin

The top link pin (1) is designed for category II and III.

KM000-107

Category II (cat. II)

„ Loosen the linch pin (3) and pull out the top link pin (1).

„ Insert the top link pin (1) in the position (I) or (II) and through the ball sleeve cat. II (2).

The thicker journal of the top link pin (1) is facing outwards.

„ Secure the top link pin with the linch pin (3).

„ Make sure that the anti-twist lock (4) of the top link pin is in the recess.

Category III (cat. III)

„ Insert the top link pin (1) in the position (I) or (II) and through the ball sleeve cat. III (2).

The thinner journal of the top link pin (1) is facing outwards.

„ Secure the top link pin with the linch pin (3).

„ Make sure that the anti-twist lock (4) of the top link pin is in the recess.

EasyCut B 970

Original operating instructions 150000711_04_us 47

advertisement

Related manuals

advertisement

Table of contents