Adapting universal shaft. Krone BA EasyCut B 970

Add to My manuals
110 Pages

advertisement

Adapting universal shaft. Krone BA EasyCut B 970 | Manualzz

6.6

Initial operation

Adapting universal shaft

6

6.6

Setting the clearance between tractor and machine

„ Observe the safety routines,

see Page 25 .

„

Disconnect the machine from the tractor, see Page 68

.

„ Remove the bolt (3) from the rear area of the impact damage protection system.

„ Move the impact damage protection systems in the hole pattern and secure with the bolt.

Æ Pos. I = shortest distance from tractor

Æ Pos. II = longest distance from tractor

„ Ensure that the impact damage protection system has the same setting on the right and left.

Adapting universal shaft

NOTICE

Changing the tractor

There is a risk of damaging the machine if the length of the universal shaft is not checked when the tractor is changed.

„ To prevent damage to the machine, check the length of the universal shaft whenever you change tractors. Have it corrected by a KRONE service partner if necessary.

KMG000-047

ü The machine is connected to the tractor,

see Page 53 .

„ Raise machine until the PTO shaft end of the tractor and the drive shaft of the machine are on the same height.

„

Shut down and safeguard the machine, see Page 25

.

„ Disassemble the universal shaft.

„ Install one of the two halves (1, 2) on the tractor side and one on the machine side.

„ Shorten profile tubes and guard tubes as specified in the operating instructions of the universal shaft manufacturer.

NOTICE: Material damage caused by failure to achieve profile overlap! Observe an overlap (shift length) of the profile tubes and guard tubes of at least 200 mm, refer to the operating instructions of the universal shaft manufacturer.

„ Check the overlapping of profile tubes and guard tubes.

The ends of the enclosed universal shaft are equipped with a longer and a shorter guard over the joints. The joint with the longer guard must be pushed towards the machine onto the drive shaft.

EasyCut B 970

Original operating instructions 150000711_04_us 49

advertisement

Related manuals

advertisement

Table of contents