7
7.6
7.6
Start-up
Connecting road travel lighting
Connecting road travel lighting
NOTICE
Short circuit caused by impurities and moisture in the plug connection
The machine may be damaged by a short circuit.
Make sure that the plugs and sockets are clean and dry.
7.7
KMG000-013
The road travel lighting is connected by means of the enclosed 7-pin lighting cable (2).
ü
The machine has been shut down and secured, see Page 25
.
Connect the 7-pin plug of the lighting cable (2) to the 7-pin socket (1) of the machine.
Connect the 7-pin plug of the lighting cable (2) to the 7-pin socket (3) of the tractor.
Route the lighting cable (2) so that it does not come into contact with the tractor wheels or other moving parts of the machine.
Installing universal shaft
WARNING
Risk of injury by failure to take account of the danger zone of the universal shaft
If the danger zone of the universal shaft is ignored, persons can be seriously hurt or killed.
To avoid accidents, observe the danger zone of the universal shaft,
see Page 16
.
NOTICE
Changing the tractor
There is a risk of damaging the machine if the length of the universal shaft is not checked when the tractor is changed.
To prevent damage to the machine, check the length of the universal shaft whenever you change tractors. Have it corrected by a KRONE service partner if necessary.
56
EasyCut B 970
Original operating instructions 150000711_04_us
Start-up
Installing universal shaft
7
7.7
KMG000-048
ü
The machine has been shut down and secured, see Page 25
.
ü The length of the PTO shaft is adapted as required by the currently used tractor.
Slip the universal shaft (1) onto the PTO shaft end of the tractor and secure it.
Secure the universal shaft guard with the supporting chain (2) against turning along with the shaft.
EasyCut B 970
Original operating instructions 150000711_04_us 57
