11
Maintenance - General Information 11
Maintenance table 11.1
Maintenance - General Information
WARNING
Risk of injury due to non-observance of relevant safety notices
If the relevant safety notices are not observed, persons may get seriously injured or killed.
To avoid accidents, the basic safety instructions must be read and observed, see
Page 13 .
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
The safety routines must be read and observed to avoid accidents,
see Page 25 .
WARNING
Risk of injury caused by test run of the machine
If a test run is performed after repair, maintenance or cleaning work or after technical intervention, the machine may behave unpredictably. Thus there is a risk of serious injuries or death.
ü The machine is in working position.
Do not switch on the drives until the mower is resting on the ground and you are absolutely sure that there is no one in the danger zone.
The test run of the machine must only be started from the driver's seat.
11.1
11.1.1
Maintenance table
Maintenance – Before the season
Checking oil level
Input gearbox
Main gearbox
Cutterbar
see Page 90
see Page 91
see Page 98
Components
Change/replace blades
Check/replace cutting discs/mower drums
Check/change retaining bolts (blade screw connection)
Check/replace retaining bolts (blade quick fastener)
see Page 94
Only by KRONE service partner, see manual for service technicians
Only by KRONE service partner, see manual for service technicians
Only by KRONE service partner, see manual for service technicians
Check/change blade carrier (blade quick fastener)
Only by KRONE service partner, see manual for service technicians
Check/replace abutting edge on the cutterbar
see Page 97
Vent friction clutch
see Page 83
EasyCut B 970
Original operating instructions 150000711_04_us 77
