Changing blades for the “blade quick fastener” version. Krone BA EasyCut B 970

Add to My manuals
110 Pages

advertisement

Changing blades for the “blade quick fastener” version. Krone BA EasyCut B 970 | Manualzz

14 Maintenance - Cutterbar

14.2

Check/change blades

INFO: The blades for anti-clockwise and clockwise rotating cutting discs/mower drums differ.

When installing the blades, ensure that the direction of rotation is correct. The arrow on the blade must match the direction of rotation of the corresponding cutting disc/mower drum.

„ Insert the new blade (5) between the wear skid (2) and the cutting disc (1).

„ Insert the retaining bolt (3) from below through the wear skid (2), the blade (5) and the cutting disc (1).

INFO: Only use the locknut (4) once.

„ Screw the locknut (4) from above onto the retaining bolt (3) and tighten it; tightening torque

see Page 79

.

„ Repeat the process for all blades.

„

Fold down the front guard, see Page 59

.

INFO

Clockwise rotating blades can be ordered by stating order number 00 139 889 *.

Anticlockwise rotating blades can be ordered by stating order number 00 139 888 *.

14.2.3

Changing blades for the “blade quick fastener” version

1

2 3

4

96

4

5

2

3

KM000-045

ü

The machine is in the working position, see Page 62 .

ü

The machine has been shut down and secured, see Page 25

.

„

Fold up the front guard, see Page 59

.

WARNING! Risk of injury due to sharp blades! Wear suitable protective gloves.

„ Clean the area around the blades, cutting discs and mower drums.

„ To remove the blade (2), insert the blade wrench (1) between the cutting disc (4) and the blade carrier (3) as far as it will go, press it down with one hand and hold it.

„ Check the fastening parts of the blade (2). Also replace worn or damaged fastening parts.

INFO: The blades for anti-clockwise and clockwise rotating cutting discs/mower drums differ.

When installing the blades, ensure that the direction of rotation is correct. The arrow on the blade must match the direction of rotation of the corresponding cutting disc/mower drum.

„ To insert the new blade (2), insert the blade key (1) between the cutting disc (4) and the blade carrier (3) as far as it will go, press it down with one hand and hold it.

„ Guide the blade (2) onto the retaining bolt (5) and release the blade key (1) in a controlled manner with your hand.

„ Repeat the process for all blades.

„

Fold down the front guard, see Page 59

.

EasyCut B 970

Original operating instructions 150000711_04_us

advertisement

Related manuals

advertisement

Table of contents