Software Setup. Balboa Water Group Revolution

Transforming the Control of Hot Tubs

Revolution

Software Setup

Note : Software Setup is changed through the panel, and is only necessary if the wiring configuration is changed from factory default (Setup 1). If the factory default had not been changed, this section can be skipped.

!

A Power OFF, and then a Power ON is recommended during this process.

Upon power up, the No. 1 DIP switch on the logic board must be set to S-1 (ON) for proper setup.

1. Shut off power. Remove Lid.

1

2

S1

6

1

Remove Lid

2. Place DIP switch No. 1 on the logic board to the ON position.

70

Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,

834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.

3

4

Transforming the Control of Hot Tubs

Revolution

Software Setup (cont.)

3. Turn the power on.

4. Once RUN PMPS PUG AIR ---- appears, press TEMP twice.

The temperature display flashes.

71

Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,

834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.

Run pumps to purge the air

Transforming the Control of Hot Tubs

Revolution

Software Setup (cont.)

5. Press LIGHT > TEMP > LIGHT

TEST will appear.

5

READY

JETS

RANGE FLTR1

The temperature flashes.

6

SET

SET

Press repeatedly until a setup choice appears

(S 01 - S 08)

6. Press TEMP repeatedly until your choice of S 01 - S 08 appears.

SET SET

72

Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,

834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.

7

8

SET

AUX LIGHT T

Transforming the Control of Hot Tubs

Revolution

Software Setup (cont.)

7. Stop at your chosen setup. Press LIGHT to enter your choice into the

configuration system. Press LIGHT again to exit the menu.

Press LIGHT twice

S1

6

1

8. Power down. Place DIP switch No. 1 to the OFF position.

9 9. Software configuration is complete. Replace Lid.

73

Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,

834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.

Transforming the Control of Hot Tubs

Revolution

Spa Information

74

Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,

834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.