HINTS AND TIPS. AEG T8DC49BS
Add to my manuals32 Pages
AEG T8DC49BS tumble dryer offers efficient drying results with its innovative features. Equipped with a heat pump technology, it gently dries clothes at low temperatures, reducing energy consumption and protecting fabrics. The AbsoluteCare® system adjusts the drying cycle to the type of fabric, preventing shrinking and maintaining the softness of your garments. The ProSense technology automatically adjusts the drying time based on the load, saving time and energy.
advertisement
18 www.aeg.com
9.8 Starting a program
4
To start the program:
Touch the Start/Pause button.
The appliance starts and the LED above the button stops flashing and stays on.
9.9 Program change
To change a program:
1.
Push the On/Off button to turn the appliance off.
2.
Push the On/Off button again to turn on the appliance.
3.
Set a new program.
10.
HINTS AND TIPS
10.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which are specified in the programs chapter.
• Clean the filter after each drying cycle.
• Do not use fabric softener to wash and then dry. In the tumble dryer laundry becomes soft automatically.
• Use distilled water like that used for steam ironing. If it is necessary, clean the distilled water before (e.g. with a coffee filter) to remove any particles.
• Always keep the airflow slots at the bottom of the appliance clear.
• Make sure there is good airflow where the appliance is to be installed.
10.2 Adjustment of default dryness level
To change the default dryness level:
1.
Turn the appliance on.
9.10 Program end
Clean the filter and drain the water container after each drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the
Buzzer option is activated, the acoustic signal sounds intermittently for 1 minute.
If you do not turn off the appliance, the anti-crease phase starts (not active with all programs). Flashing symbol signals the execution of the anticrease phase.
Laundry can be removed during this phase.
To remove the laundry:
1.
Push the On/Off button for 2 seconds to turn the appliance off.
2.
Open the appliance door.
3.
Remove the laundry.
4.
Close the appliance door.
2.
Select 1 of the available programs.
3.
Touch and hold down the Extra
Silent and Steam Level buttons at the same time.
One of the symbols appears on the display:
- Maximum dryness
- Extra dryness
- Standard dryness
4.
Touch the Start/Pause button repeatedly until you reach the desired dryness level.
Dryness level
Maximum dryness
Display symbol
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 SAFETY INFORMATION
- 5 SAFETY INSTRUCTIONS
- 7 PRODUCT DESCRIPTION
- 8 CONTROL PANEL
- 9 PROGRAM
- 12 OPTIONS
- 13 STEAM FUNCTION
- 15 BEFORE FIRST USE
- 15 DAILY USE
- 18 HINTS AND TIPS
- 19 CARE AND CLEANING
- 23 TROUBLESHOOTING
- 25 TECHNICAL DATA
- 26 ACCESSORIES