Driver Setup. Graco 3A5379B, Electric Supply System for Sealants and Adhesives

Add to My manuals
52 Pages

advertisement

Driver Setup. Graco 3A5379B, Electric Supply System for Sealants and Adhesives | Manualzz

Driver Setup

Driver Setup

1. Pull the driver pressure adjustment knob (AK) out and turn counterclockwise until it stops. Push the knob in to lock.

AK

Pump Operation

The driver will adjust the speed to maintain a constant fluid pressure.

Pull the driver pressure control knob (AK) out to set.

Turn the knob clockwise to increase the pressure, or counter-clockwise to decrease the pressure. Push the knob to lock. See F IG . 12.

ti20171a_1

F IG . 12: Driver Pressure Adjustment Knob

2. Turn the disconnect switch (K) OFF. Connect the unit to the power source. See F IG . 5, page 10.

Mechanical Setup

1. Fill the displacement pump wet cup 2/3 full with

Graco Throat Seal Liquid (TSL).

2. Back-off the air regulator to its full counterclockwise position and close all shutoff valves.

3. Connect the air line from an air source to the system air inlet. See F IG . 1. Use a supply hose capable of meeting the required flow.

3A5379B 13

advertisement

Related manuals