advertisement
SECTION 5 – INSTALLATION
5-1.
Installing Cylinders
161-018
Install cylinders in an upright position by securing to a stationary support or cylinder rack to prevent falling or tipping. Maintain a clear path from the cylinders to the work area.
Inspect equipment before use. Do not use if grease or oil is present on equipment or if equipment is damaged.
Have equipment cleaned/repaired by a qualified person.
Do not slightly open or "crack" fuel cylinder valve to blow debris from the valve outlet. Remove the debris using nitrogen, air, or a clean, oilfree rag.
Remove the protective cap from the cylinder valve.
Use nitrogen, air, or a clean oil-free rag to remove dust or debris from valve outlet. These particles can damage regulators or cause a fire or explosion.
OM-251341 Page 13
advertisement
