Installing Cutting Attachment On Torch Handle. HobartWelders OXY-FUEL OUTFITS 770502, 770974

allen_wrench allen_set

5-6.

Installing Cutting Attachment On Torch Handle

1 rubbergloves weldgloves earmuffs

NGO’s tools/

2 ear plugs electrodewrench

Do not use cutting attachment if the o-rings are missing or damaged.

Do not use pipe sealants on metal to metal fittings, such as hose and torch connections and CGA cylinder connections.

�

See Section 5-8 for attaching brazing

tip to torch handle.

1 Cutting Attachment

2 Torch Handle

The cutting attachment uses two o-rings to seal the connection to the torch handle. If replacing the cutting attachment, be sure the o-rings are properly installed.

helmet weldshield faceshield

Attach cutting attachment to torch handle.

Use a wrench to tighten connections.

161-032

NGO’s tools/ flathead philips head glasses 3/4 in.

wrench hairdryer crescent wrench cclamp rpmmeter

5-7.

Installing Cutting Tip On Cutting Attachment

benchvise popriveter pliers solderiron torque screwdriver torque wrench allen_wrench needlenose stripcrimp socket wrench allen_set knife heavy-duty workclamp drill steelbrush

NGO’s tools/ light-duty workclamp flathead handream nutdriver oilcan

1 filtersocket chippinghammer rubbergloves weldgloves pinextractor2 greasegun philips head filterwrench

T_allen glasses 1 in.

pinextractor (141761) hairdryer wrench crescent wrench

OM-251341 Page 17 earmuffs tip_dress pencil

NGO’s tools/ belttensiongauge

Do not use pipe sealants on metal tape torch connections and CGA cylinder connections.

NOTICE – Do not drop or mishandle the cutting tip or the seating surface may be damaged.

fusepuller

Cutting tips are available in different sizes to accommodate various metal thicknesses.

Use the tables in Sections 4-4 and 4-5 to se-

lect the correct tip, and to determine the cormallet scissors ear plugs electrodewrench sealant_2

161-033

Inspect cutting tips for damage and to ensure that the cutting orifice and preheat holes are not blocked with dirt or slag.

helmet weldshield faceshield

�

A No. 0 cutting tip is already installed in the cutting attachment with the Medium

Torx

1 Cutting Tip

2 Cutting Attachment

SOAP bar soap cclamp rpmmeter

Install correct cutting tip in cutting attachment.

benchvise

Paper Clip popriveter strapwrench pliers airgun needlenose knife hammer awl steelbrush

Needle-Nose Vise Grip file nutdriver oilcan paintbrush filtersocket chippinghammer

Ground Strap

Thermal Compound

Trowel hacksaw

Chisel belttensiongauge sealant_1 tape flashlight snapringpliers linepliers pencil fusepuller mallet

OM-222 Page 1 scissors punch torque wrench socket wrench strapwrench drill solvent pinextractor pinextractor2 eprompuller pipewrench tip_dress greasegun

T_allen pinextractor (141761) handream hammer awl

SOAP sealant_2 bar soap

Needle-Nose Vise Grip file paintbrush

Ground Strap

Thermal Compound

Trowel pump pliers

Liquid soap Paper Clip

Chisel

Torx airgun

OM-222 Page 1 qtip (swab) vicegrip crimper feelergauge flashlight ruler toothbrush punch solvent pinextractor eprompuller pipewrench

OM-222 Page 1