3.10.2 ATX Power Mode. IEI Technology POC-17C-ULT3

POC-17C-ULT3 Medical Panel PC

3.10.2 ATX Power Mode

With the ATX mode selected, the POC-17C-ULT3 panel PC goes in a standby mode when it is turned off. The panel PC can be easily turned on via network or a power switch in standby mode.

3.11 Cable Cover Installation

An optional cable cover can be installed on the POC-17C-ULT3 for the user to easily manage cables. To install the cable cover, please follow the instruction below.

Step 1: Align the slot on the rear of the cable cover with the tab on the bottom panel of

the POC-17C-ULT3 ( Figure 3-25

). Then, attach the slot to the tab.

Figure 3-25: Aligning the Tab on the Bottom Panel

Step 2: Push six tabs on the cable cover (as shown in

Figure 3-26)

into the slots on the rear panel of the POC-17C-ULT3. More strength is required to push the tabs into the slots.

Page 37

POC-17C-ULT3 Medical Panel PC

Figure 3-26: Cable Cover Installation

Step 3: To remove the cable cover, push the tabs inwards to release the cover (

Figure

3-27 ), and lift the cover from the POC-17C-ULT3.

Figure 3-27: Cable Cover Removal

Page 38