3.12.1 Wall Mounting. IEI Technology POC-17C-ULT3

POC-17C-ULT3 Medical Panel PC

3.12 Mounting the System

The methods of mounting the POC-17C-ULT3 are listed below.

ƒ Wall

ƒ Arm

ƒ Stand

The mounting methods are described below.

WARNING:

Use suitable mounting apparatus and be sure to secure the screws of the mounting apparatus tightly to avoid risk of injury.

3.12.1 Wall Mounting

To mount the medical panel PC onto the wall, please follow the steps below.

Step 1: Select the location on the wall for the wall-mounting bracket.

Step 2: Carefully mark the locations of the four screw holes in the bracket on the wall.

Step 3: Drill four pilot holes at the marked locations on the wall for the bracket retention screws.

Step 4: Align the wall-mounting bracket screw holes with the pilot holes.

Step 5: Secure the mounting bracket to the wall by inserting the retention screws into

the four pilot holes and tightening them ( Figure 3-28

).

Page 39

POC-17C-ULT3 Medical Panel PC

Figure 3-28: Wall-mounting Bracket

Step 6: Insert the four monitor mounting screws provided in the wall mount kit into the four screw holes on the real panel of the medical panel PC and tighten until the screw shank is secured against the rear panel (

Figure 3-29 ).

WARNING:

Please use the M4 screws provided in the wall mount kit for the rear panel.

If the screw is missing, the thread depth of the replacement screw should be not more than 4 mm.

Step 7: Align the mounting screws on the monitor rear panel with the mounting holes on the bracket.

Page 40

POC-17C-ULT3 Medical Panel PC

Step 8: Carefully insert the screws through the holes and gently pull the monitor

downwards until the monitor rests securely in the slotted holes ( Figure 3-29

).

Ensure that all four of the mounting screws fit snugly into their respective slotted holes.

NOTE:

In the diagram below the bracket is already installed on the wall.

Figure 3-29: Chassis Support Screws

Page 41