3.12.2 Arm Mounting. IEI Technology POC-17C-ULT3

POC-17C-ULT3 Medical Panel PC

Step 9: Secure the panel PC by fastening the retention screw of the wall-mounting bracket (

Figure 3-30 ).

Figure 3-30: Secure the Panel PC

3.12.2 Arm Mounting

The POC-17C-ULT3 is VESA (Video Electronics Standards Association) compliant and can be mounted on an arm with a 75 mm or a 100 mm interface pad. To mount the

POC-17C-ULT3 on an arm, please follow the steps below.

Step 1: The arm is a separately purchased item. Please correctly mount the arm onto the surface it uses as a base. To do this, refer to the installation documentation that came with the mounting arm.

Page 42

POC-17C-ULT3 Medical Panel PC

NOTE:

When purchasing the arm please ensure that it is VESA compliant and that the arm has a 75 mm or a 100 mm interface pad. If the mounting arm is not

VESA compliant it cannot be used to support the POC-17C-ULT3 medical panel PC.

Step 2: Once the mounting arm has been firmly attached to the surface, lift the panel PC onto the interface pad of the mounting arm.

Step 3: Align the retention screw holes on the mounting arm interface with those in the

panel PC ( Figure 3-31

).

Figure 3-31: VESA 75 and VESA 100 Mounting Retention Screw Holes

Step 4: Secure the POC-17C-ULT3 to the interface pad by inserting four retention screws through the mounting arm interface pad and into the POC-17C-ULT3.

Page 43