3.12.3 Stand Mounting. IEI Technology POC-17C-ULT3

POC-17C-ULT3 Medical Panel PC

Figure 3-32: Arm Mounting

3.12.3 Stand Mounting

To mount the POC-17C-ULT3 using the stand mounting kit, please follow the steps below.

Step 1: Locate the VESA mounting screw holes on the rear of the POC-17C-ULT3

(

Figure 3-31 ). This is where the bracket will be attached.

Step 2: Align the bracket of the stand with the screw holes.

Step 3: To secure the bracket to the POC-17C-ULT3, insert the retention screws into the screw holes and tighten them.

NOTE:

If the EZ stand (MEDP-EZS-R10) is mounted, the handle

(MEDP-HD-R10 or MEDP-HD-BR-R10) can not be installed.

Page 44

POC-17C-ULT3 Medical Panel PC

3.13 Powering On the System

WARNING:

To avoid risk of electric shock, this equipment must only be connected to supply mains with protective earth.

CAUTION:

The FSP PMP120-13-2 power adapter came with the POC-17C-ULT3 is a forming part of the medical device.

To power on the system, follow the steps below:

Step 1: Connect the power cord to the power adapter. Connect the other end of the power cord to a power source.

Step 2: Connect the power adapter to the power connector of the POC-17C-ULT3.

Step 3: Locate the power button on the rear panel.

Step 4: Short press the power button to turn on the POC-17C-ULT3.

The user can also long-press the touch buttons on the front panel

for three seconds to power on the system (please refer to Table 1-2

). Step 0:

Figure 3-33: Powering On the System

Page 45

POC-17C-ULT3 Medical Panel PC

3.14 Reset the System

The reset button enables user to reboot the system when the system is turned on. The reset button location is shown in

Figure 3-34 . Press the reset button to reboot the system.

Figure 3-34: Reset Button Location

Page 46