3.10.1 AT Power Mode. IEI Technology POC-W24C-ULT3

POC-W24C-ULT3 FHD Medical Panel PC

3.10 AT/ATX Mode Selection

AT or ATX power mode can be used on the POC-W24C-ULT3. The selection is made through an AT/ATX switch located on the bottom panel (

Figure 3-23 ).

Figure 3-23: AT/ATX Switch Location

3.10.1 AT Power Mode

With the AT mode selected, the power is controlled by a central power unit rather than a power switch. The POC-W24C-ULT3 panel PC turns on automatically when the power is connected.

3.10.2 ATX Power Mode

With the ATX mode selected, the POC-W24C-ULT3 panel PC goes in a standby mode when it is turned off. The panel PC can be easily turned on via network or a power switch in standby mode.

3.11 Mounting the System

The methods of mounting the POC-W24C-ULT3 are listed below.

ƒ Wall

ƒ Arm

ƒ Stand

The mounting methods are described below.

WARNING:

Use suitable mounting apparatus and be sure to secure the screws of the mounting apparatus tightly to avoid risk of injury.

Page 37