3.11.3 Stand Mounting. IEI Technology POC-W24C-ULT3

POC-W24C-ULT3 FHD Medical Panel PC

3.11.3 Stand Mounting

To mount the POC-W24C-ULT3 using the stand mounting kit, please follow the steps below.

Step 1: Locate the VESA mounting screw holes on the rear of the POC-W24C-ULT3

(

Figure 3-27 ). This is where the bracket will be attached.

Step 2: Align the bracket of the stand with the screw holes.

Step 3: To secure the bracket to the POC-W24C-ULT3, insert the retention screws into the screw holes and tighten them.

NOTE:

If the EZ stand (MEDP-EZS-R10) is mounted, the handle

(MEDP-HD-R10 or MEDP-HD-BR-R10) can not be installed.

3.12 Powering On the System

WARNING:

To avoid risk of electric shock, this equipment must only be connected to supply mains with protective earth.

CAUTION:

The FSP PMP120-13-2 power adapter came with the

POC-W24C-ULT3 is a forming part of the medical device.

Page 43

POC-W24C-ULT3 FHD Medical Panel PC

To power on the system, follow the steps below:

Step 1: Connect the power cord to the power adapter. Connect the other end of the power cord to a power source.

Step 2: Connect the power adapter to the power connector of the POC-W24C-ULT3.

Step 3:

Locate the power button on the left panel ( Figure 1-4 ).

Step 4: Short press the power button to turn on the POC-W24C-ULT3.

The user can also long-press the touch buttons on the front panel

for three seconds to power on the system (please refer to Table 1-2

). Step 0:

Figure 3-29: Power Input Connector

3.13 Reset the System

The reset button enables user to reboot the system when the system is turned on. The reset button location is shown in

Figure 3-30 . Press the reset button to reboot the system.

Figure 3-30: Reset Button Location

Page 44