ASSEMBLY. Mi-T-M Propane Tank-Top Radiant Portable Heater

ASSEMBLY

VENTILATION

For this heater, provide a minimum of 48 square inches of space by opening a window or door to provide fresh, outside air. For additional heaters, provide more ventilation. Provide at least 3 square feet of opening for ventilation per 100,000 Btu of rated operation.

ASSEMBLY

Note: Tools required: Medium phillips screwdriver

1. Place Tank Collar Bracket on top of Center Plate. Be sure Mounting Bolt Knob is on bottom as shown.

2 Insert Machine Screw into top hole using Phillips screwdriver.

3. Insert 2nd Machine screw into bottom hole. This will secure the Tank Collar Bracket to the Center Plate.

NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A FUEL

SOURCE.

CONNECTING HEATER TO LP CYLINDER

Be sure to read and understand all of the Safety Information in this manual before connecting the heater to the LP cylinder.

SINGLE BURNER MODELS ONLY

1. Be sure that the control knob on the regulator is in the

“OFF” position.

Ignition Hole

2. Line up the threads on the Fuel Connector Nut with the threads on the LP cylinder valve. Turn Fuel Connector Nut counterclockwise to tighten. Fully tighten the nut, being careful not to overtighten.

3. Slowly open the LP cylinder valve.

4. Check all connections for leaks using a 50/50 mixture of dishsoap and water. Any bubbles appearing show a leak.

Remove and reconnect the Connector Nut to the valve.

DOUBLE BURNER MODELS ONLY

1. Be sure that the control knob on the regulator is in the

“OFF” position.

Safety Shut-Off

Valve Plunger

Heat Regulator Knob

Tip over Switch

Assembly

2. Line up the slots in the tank collar bracket with the tank collar ring and slide into place. Be sure the mounting knob is to the outside, and tighten.

3. Line up the threads on the Fuel Connector Nut with the threads on the LP cylinder valve. Turn Fuel

Connector Nut counterclockwise to tighten. Fully tighten the nut, being careful not to overtighten.

4. Slowly open the LP cylinder valve.

5. Check all connections for leaks using a 50/50 mixture of dishsoap and water. Any bubbles appearing show a leak. Remove and reconnect the Connector Nut to the valve.

Swivel

Machine

Screws Regulator

Knob

BE SURE TO READ AND UNDERSTAND ALL

OF THE SAFETY INFORMATION IN THIS

MANUAL BEFORE LIGHTING THIS HEATER.

HEATER HAS HIGH SURFACE TEMPERATURES.

BE SURE TO KEEP CHILDREN, PETS AND

CLOTHING AWAY FROM THE HEATER. BE

SURE TO KEEP BURNER AND HEATER

REGULATOR CLEAN AND FREE FROM

ANY DEBRIS. MAINTAIN SAFE DISTANCES

FROM HEATER AS SHOWN.

Manifold Fuel Connector Nut

Mounting Bolt Knob

Tank Collar Bracket

12 Propane Tank Top Heaters Manual