Overflow Drain Hole Cutouts. Jacuzzi OSM6732BUXXXXG 36 Pages
Overflow Drain Hole Cutouts. Jacuzzi OSM6732BUXXXXG
advertisement
Overflow Drain Hole Cutouts
Cutout (Fig. 4)
Linear Drain
Rotary Drain
Avvio Collection
Deep Soak Drain
Slip Cover Drain
Drain Part Number
MF35XXX
HP55XXX
Integral
LH33XXX
PG35XXX
Freestanding Baths
0.63”
(16mm)
0 2.5”
(63.5mm)
MF35
HP55
PG35
0.38”
(9.65mm)
SOLID
SURF
ACE
LH33
Installation Instructions for 2-Piece Tub
1 Set the 2-piece tub in place and position
it precisely with respect to the drain-
overflow location. Verify where the
indentation for the drain is in relation
to the drain-overflow. Use a marker to
outline the perimeter of the entire tub
directly on the floor (Fig. 5).
2
3
Mark a trough for the overflow drain
location on the floor. The drain-
oveflow extends below the
bottom of the bath. The drain-
overflow requires a cutout of the floor
for providing space to accommodate
the extension. Do not exceed the
dimensions of the tub perimeter.
When the above locations have been
marked on the floor, remove the
tub base (skirt), set it aside and
continue with the installation process.
Silicone
Side
Views
Bottom
Views
Silicone
4
5
Faucetry is not supplied with the
freestanding bath. To use deck-
mounted faucetry, flexible connection
lines that are 72” in length must be
used. These lines need to be installed prior to installating the bath into the skirt.
When installing the faucet on the same side as the overflow, make sure there is no interference between the two before
drilling.
6 Use silicone to attach the tub skirt to the Sub floor. Make sure the tub is properly oriented according to the drain-overflow
end. Place the tub skirt on the floor in relation to the drain/overflow. Place the tub skirt on the floor an line up with the
markings prevously made on the floor.
7 Apply silicone to the foam feet or bottom of the adjustable feet. Carefully place the tub into the tub skirt in relation to the
drain/overflow. Allow silicone to dry for 24-hours before entering and/or using the tub.
Page 6 www.jacuzzi.com
Installation Instructions
advertisement
Related manuals
advertisement
Table of contents
- 1 Contents
- 2 Safety Instructions
- 4 Inspection and Testing
- 4 Sub Floor
- 4 Deck Mount Faucet Installation
- 5 Installation Instructions for 1-Piece Tub with Integral Overflow
- 5 Installation Instructions for 1-Piece Tub
- 6 Overflow Drain Hole Cutouts
- 6 Installation Instructions for 2-Piece Tub
- 7 Installation Instructions for Remote Blower
- 7 or Heated Soak
- 8 Installation Instructions for Bianca Whirlpool Drain Installation
- 9 Acylic Bathtub Maintenance
- 9 Solid Surface Care and Cleaning Instructions
- 10 Notes
- 11 Warranty Registration Card
- 13 Contenido
- 14 Instrucciones de seguridad
- 16 Inspección y prueba
- 16 Contrapiso
- 17 Instrucciones de instalación para bañeras de 1 pieza con desborde integral
- 17 Instrucciones de instalación para bañeras de 1 pieza
- 18 Instrucciones de instalación para bañeras de 2 piezas
- 19 Instrucciones de instalación para generadores de burbujas de aire con control remoto
- 19 o sistema de climatización constante
- 20 Instrucciones de instalación para el drenaje de Hidromasaje Bianca
- 21 Mantenimiento de bañeras de acrílico
- 22 Notas
- 23 Tarjeta de registro de la garantía
- 25 Table des matières
- 26 Consignes de sécurité
- 28 Inspection et essai
- 28 Sous-plancher
- 29 Consignes d’installation : baignoire 1 pièce avec trop-plein intégré
- 29 Consignes d’installation : baignoire 1 pièce
- 30 Consignes d’installation : baignoire 2 pièces
- 31 Consignes d’installation : baignoire 2 pièces avec système Whisper+ TechnologyMC ou Heated Soak
- 32 Directives d’installation du drain du bain tourbillon Bianca
- 33 Entretien des baignoires acycliques
- 33 Consignes de nettoyage et d’entretien des surfaces solides
- 34 Remarques
- 35 Fiche d’enregistrement de garantie