Preparing ThermoLazer™ for Application. Graco 3A1319C - ThermoLazer and ThermoLazer ProMelt Pavement Marking Systems

Add to My manuals
30 Pages

advertisement

Preparing ThermoLazer™ for Application. Graco 3A1319C - ThermoLazer and ThermoLazer ProMelt Pavement Marking Systems | Manualzz

Preparing ThermoLazer

for Application

Preparing ThermoLazer

for Application

6.

Move ControlFlow

Gate Valve Actuator (S) to raised position and fill screed box with melted thermoplastic material.

Keep all access covers closed and latched when equipment is in use.

Always secure ThermoLazer

by chocking wheels when adding thermoplastic.

S

0.5 in.

1.

Secure the unit by chocking wheels and applying parking brake.

2.

Make sure kettle burners and SmartDie

screed box burner are lit.

3.

Allow kettle to heat up before adding material. If kettle is completely empty, allow kettle to reach

300° - 350° F (149° - 177° C) before adding material. If kettle has material, allow material to reach

380° F (193° C) before adding material.

4.

Secure ThermoLazer

by chocking wheels.

ti14123a

NOTE: The material gate is adjustable. The gate is factory set at a 0.5 in. (1.3 cm) gap. You can increase this gap for more material flow or decrease the gap for less material flow.

7.

Do not overfill material in kettle. Overfill would be material higher than 5 in. (13 cm) below top of kettle.

5.0 in.

Overfill

Line ti14603a

5.

Add thermoplastic material to kettle.

ti14410a

8.

Close and latch cover access doors when applying thermoplastic.

9.

Avoid bumping or impacting Thermolazer

to prevent spillage or splashing of hot material.

ti14122a

20 3A1319C

advertisement

Related manuals