Clean-Up for ThermoLazer™. Graco 3A1319C - ThermoLazer and ThermoLazer ProMelt Pavement Marking Systems

Add to My manuals
30 Pages

advertisement

Clean-Up for ThermoLazer™. Graco 3A1319C - ThermoLazer and ThermoLazer ProMelt Pavement Marking Systems | Manualzz

Clean-Up for ThermoLazer

Clean-Up for ThermoLazer

Never scoop out remaining melted thermoplastic from kettle. Remaining thermoplastic can be left to harden inside the kettle and can be remelted at a later date.

1.

Secure ThermoLazer

by chocking wheels.

ti14603a

2.

Use scraper to clean out trough and screed box.

NOTICE

Be sure to thoroughly clean all material out of screed box and any open areas to prevent material from freezing moving parts of screed box. Always run all material out of each screed box before removing. Scrape out all remaining material before it sets within the screed box.

NOTICE

To prevent material from hardening and blocking flow, scrape all excess material off of external surfaces after each use, including the material trough.

NOTICE

Remove any remaining beads in the bead hopper and bead dispenser to prevent beads from clogging hopper and dispenser.

Transporting

Remove LP-Gas supply cylinder from ThermoLazer

™ before transporting. Secure in an approved location and method as authorized by local, state, federal, national, and international agencies.

Always use the designated mounted lifting lugs when lifting the Thermolazer

. When lifting the Thermolazer

™ only use ANSI approved slings and equipment rated for a minimum of 2000 lb. Always use ANSI approved equipment for securing ThermoLazer to transporting equipment.

ti14529a

3A1319C 25

advertisement

Related manuals