Clean-Up for ThermoLazer™ ProMelt™. Graco 3A1319C - ThermoLazer and ThermoLazer ProMelt Pavement Marking Systems

Add to My manuals
30 Pages

advertisement

Clean-Up for ThermoLazer™ ProMelt™. Graco 3A1319C - ThermoLazer and ThermoLazer ProMelt Pavement Marking Systems | Manualzz

Clean-Up for ThermoLazer

ProMelt

Clean-Up for ThermoLazer

ProMelt

Never scoop out remaining melted thermoplastic from kettle without proper Personal Protective Equipment.

8.

Repeat step 7.

9.

Rotate agitator handle to 3 o’clock and hold at this position by using the cover latch.

10. Use small scraper to clean out trough, screed box, and agitators.

1.

Secure unit by chocking all three wheels.

NOTE: Flow can be increased by propping up the left rear wheel and securing unit by chocking the other two wheels. ti14529a ti14603a

2.

Fully engage and lock brake.

3.

Rotate agitator handle to 9 o’clock and hold at this position by using the cover latch.

NOTICE

Be sure to thoroughly clean all material out of screed box and any open areas to prevent material from freezing moving parts of screed box. Always run all material out of each screed box before removing. Scrape out all remaining material before it sets within the screed box.

NOTICE

To prevent material from hardening and blocking flow, scrape all excess material off of external surfaces after each use.

ti15950a

4.

Turn kettle burners ON to melt material.

5.

Open material gate and pour out remaining material in a heat-resistant container.

6.

Turn kettle burners OFF.

7.

Use long-handled scraper tool (VV) to remove material from inside of kettle. Start by scraping from the top of the kettle sides and work your way down so that as soon as the material collecting at the bottom begins to cool and harden you can scoop it out of the kettle. Collect material in a heat-resistant pan.

NOTE: If material becomes too hard to scrape or remove, reheat the kettle until the material becomes soft again.

NOTICE

Remove any remaining beads in the bead hopper and bead dispenser to prevent beads from clogging hopper and dispenser.

Transporting

Remove LP-Gas supply cylinder from the unit before transporting. Secure in an approved location and method as authorized by local, state, federal, national, and international agencies.

Always use the designated mounted lifting rings when lifting the unit. When lifting the unit, only use ANSI approved slings and equipment rated for a minimum of

2000 lb. Always use ANSI approved equipment for securing the unit to transporting equipment.

26 3A1319C

advertisement

Related manuals