Supply Power to Module. Graco 3A1244D


Add to my manuals
6 Pages

advertisement

Supply Power to Module. Graco 3A1244D | Manualzz

Supply Power to Module

2

To help prevent fire and explosion, do not connect, download, or remove the token unless the unit is removed from the hazardous (explosive atmosphere) location.

NOTICE

To avoid damaging circuit board, wear a grounding strap.

• Use the token to load software to the Graco Control

Architecture Module before use. Follow all directions and warnings in this manual and your system repair/parts manual.

• Upgrade token part numbers can be found in the system manual.

• Upgrade all modules in the system to the software version on the token, even if you are replacing only one or two modules. Different software versions may not be compatible.

• All data in the module may be reset to factory default settings.

Record all settings and user preferences before the upgrade, for ease of restoring them following the upgrade.

• The latest software version for each system can be found at www.graco.com.

Supply Power to Module

Supply electrical power to the Graco Control Architecture module using either system power or Power Supply

Kit 24F672, available separately.

Software Upgrade

Instructions

Follow these instructions to upgrade the software in all of the Graco Control Architecture Modules. Reference

illustrations of each module starting on page 3.

1. Remove power from the Graco Control Architecture

Module by turning off system power or unplugging the Power Supply Kit 24F672 (available separately).

2. Remove access cover (C).

NOTE: For cube modules, the cover is removed by pressing in the two tabs. For other modules, one or more screws (S) must be removed.

3. Insert and press the token (T) firmly into the slot.

NOTE: Token has no preferred orientation.

4. Supply electrical power to the Graco Control Architecture Module using either system power or Power

Supply Kit 24F672 (available separately).

NOTE: The Motor Control Module 257696, High Power

Temperature Control Module 255774, and the Low

Power Temperature Control Module 256270 do not require power to the high voltage AC input.

5. The red indicator light (L) will flash while the software is being loaded. When the software is completely loaded, the red light will turn off.

NOTE: For the USB module only, when the red light stops flashing, the green and orange indicator lights adjacent to the USB connector will flash for several minutes while configurations are loaded. The software is completely loaded when the red, green, and orange indicator lights are off.

6. Remove power from the Graco Control Architecture

Module by turning off system power or unplugging the Power Supply Kit 24F672.

7. Remove the token (T) from the slot.

8. Reinstall the access cover and secure with screws

(S), if applicable.

9. Upgrade all other modules in the system to the software revision on the token. Different software versions may not be compatible.

NOTE: If the software on the token is the same version that is already programmed on the module, nothing will happen (including flashing red light). No harm can be done by attempting to program the module multiple times. For Communications Gateway Modules, installing upgrade software will not erase or overwrite a data map, if already loaded.

3A1244D

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals