Installation For Electric Reactor 2. Graco 333276C, 333276D


Add to my manuals
8 Pages

advertisement

Installation For Electric Reactor 2. Graco 333276C, 333276D | Manualzz

Installation For Electric Reactor 2

Installation For Electric Reactor 2

NOTICE

To prevent damage to the Graco InSite, do not expose to rain.

1. Shutdown Reactor system. See system manual for instructions.

Install Cellular Module

NOTICE

To prevent cracking the plastic shell of the cellular module (1), do not overtighten bolts (A) when installing onto bracket (2).

1. Use two bolts (A) to secure cellular module (1) to

electrical enclosure. See F IG . 2.

2. Connect 4-pin end of cable (2) to cellular module (1) connector.

3. Route cellular module cable (2) through wire tie (3) to MCM (B). Secure with wire ties (3) as needed.

4. Connect other end of cellular module cable (2) to

MCM (B) connector 14.

5. Place Graco InSite label (4) on front shroud as shown.

B

4

A

F IG . 1: Install Cellular Module

333276C

WLD

3

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals