SETUP. Meyer AMW-00091

8

SETUP

When the Turbo Broom is shipped;

• the fuel is drained

• engine oil is at full level

• the battery is strapped down and disconnected

• the caster assemblies are secured upside down in the brackets.

Before starting the engine and using the Turbo Broom the following tasks must be completed.

1. Fill the fuel tank according to the engine manual instructions.

2. Check and add (if needed) engine oil according to the engine manual instructions.

3. Remove the top of the battery box. Connect the loose wire to the proper battery terminal. The red wire connects to the positive (+) terminal.

4. Lift and support the broom head to remove the caster assemblies. Remove the pins, slide the assembly out, insert the assembly from the bottom and reinsert the pin. Refer to the section on "Brush Height Adjustment" to level the Turbo

Broom.