Specifications. Duluth Forge 170154, 170032, 170150

SAFETY

1. Do not place Propane supply tank(s) inside any structure. Propane supply tank(s) must be placed outdoors.

2. This heater shall not be installed in a bedroom or bathroom.

3. This heater needs fresh air ventilation to run properly. This heater has an Oxygen

Depletion Sensing (ODS) safety shutoff system. The ODS shuts down the heater if not enough fresh air is available. See

Air for Combustion and Ventilation , pages

6 and 7. If heater keeps shutting off, see

Troubleshooting , page 28.

4. Keep all air openings in front and bottom of heater clear and free of debris. This will ensure enough air for proper combustion.

5. If heater shuts off, do not relight until you have provided fresh, outside air. If heater keeps shutting off, have it serviced.

6. Do not run heater:

• Where flammable liquids or vapors are used or stored.

• Under dusty conditions.

7. Before using furniture polish, wax, carpet cleaner, or similar products, turn heater off. If heated, the vapors from these products may create a white powder residue within burner box or on adjacent walls or furniture.

8. Always run heater with control knob at

PILOT or ON locked positions. Never set control knob between locked positions.

Poor combustion and higher levels of carbon monoxide may result.

9. Do not use heater if any part has been under water. Immediately call a qualified service technician to inspect the room heater and to replace any part of the control system and any gas control which has been under water.

10. Turn off and unplug heater and let cool before servicing. Only a qualified service person should service and repair heater.

11. Operating heater above elevations of

4,500 feet could cause pilot outage.

12. To prevent performance problems, do not use propane fuel tank of less than 100 lbs. capacity.

13. Do not use this heater as a wood-burning heater. Use only the logs provided with the heater.

14. To prevent sooting, follow the instructions in Care and Maintenance (see page 24).

15. Do not add extra logs or ornaments such as pine cones, vermiculite, or rock wool.

Using these added items can cause sooting. Do not add lava rock around base.

Rock and debris could fall into the control area of heater. After servicing, always replace screen before operating heater.

16. This heater is designed to be smokeless. If logs ever appear to smoke, turn off heater and call a qualified service person.

Note: During initial operation, slight smoking could occur due to log curing and the heater burning manufacturing residues.

4

SPECIFICATIONS

Model FDF300R

Gas Type Natural Gas

Ignition Piezo Ignitor

Input Rating 26,000 Btu/Hr

Propane Gas

Piezo Ignitor

26,000 Btu/Hr

Pressure Regulator Setting

Inlet Gas Pressure* (inches of water)

(*for purposes of input adjustment)

4" W.C.

Maximum 9"

Minimum 5"

9.5" W.C.

Maximum 14"

Minimum 11"

Heater Dimensions (WxHxD) • 29.1" × 23.9" × 13.9"

Carton Dimensions (WxHxD) • 30.9" × 26.9" × 14.8"

Stove Weight • 47.6 lbs

Shipping Weight • 55.7 lbs www.factorybuysdirect.com

200253-01E