WEIGH SYSTEM PROGRAMMING
Host Indicator Programming (Continued)
Main Menu System
The following options are accessible through the main menu system:
Display Function
Clear All
Definition
Clear stored data and custom settings
Set Time and Date Sets Time and Date for exported data
LCD Display Backlight Sets the backlight mode for the LCD display The red oval above the display is a light sensor
Unit of Weight
Average Rate
Auto Off
Sets the weighing unit between pounds and kilograms Changing units on the Host Indicator will also change the units on the Scale Indicator
The rate at which the output of the load cells is read by the Scale Indicator
This is in 1/4 second increments Changing the rate on the Host Indicator will also change the rate on the Scale Indicator
Amount of time (in minutes) before the weigh system turns off from inactivity
Hold Enable
Print Continuous
Print Baud Rate
Activates or deactivates the capability of locking the currently displayed weight
Output the display continuously to an external display board or other device connected to the RS232 port
The rate the RS232 output occurs This must match the rate of the device attached to the RS232 port
Clear All Memory Locations
The following steps will clear saved weight accumulations in memory locations or resets ALL stored data and custom settings to their default values
Step Button Entry Option Display
Clear Memory
Enter clearing code The default selection is for leaving the memory as it was last set
Enter 9191 to clear all saved weight accumulations
Select your entered clearing code
Display will show Lost indicating the previously stored information has been changed
Field Floater 6 Grain Cart User Manual 63
