Set Display Backlight. BALZER FIELD FLOATER 6

WEIGH SYSTEM PROGRAMMING

Host Indicator Programming (Continued)

Set Display Backlight

The following steps will set the backlight of the LCD display

Step

Set LCD display backlight

Button Entry Option

Select backlight option The default selection is for leaving the backlight in Automatic This uses a light sensor on the front of the panel to turn the backlight on or off - display will be flashing

Backlight always Off

Backlight always On

Select your backlight option

Display

Set Weighing Units

The following steps will set the weighing units for recorded and displayed data The scale will read in 10 lbs/5 kg increments

Step Button Entry Option Display

Set Weighing Units

Select weighing unit options

Select your weighing unit option

The default selection is pounds (lbs) - lbs display will be flashing

Switch to kilograms (kg) - kg display will be flashing

Changing this setting will make the same change on the Scale Indicator

Adjust Average Rate

The following steps will set the rate at which the Scale indicator takes a weight reading from each load cell The rate number displayed is the number of 1/4 seconds between readings The lower the number, the more frequently a reading is taken

Step Button Entry Option Display

Set Average Rate

Select Average Rate interval

Use numeric keypad to enter new rate

Accept your new rate

The default selection is 10 - this will read each load cell every 2 1/2 seconds

The scale indicator can accept a read rate from 1 to 120 (every 1/4 second to 30 seconds) - setting the rate to 1 may give the appearance of a constantly changing scale

Changing this setting will make the same change on the Scale Indicator

Field Floater 6 Grain Cart User Manual 65