Set Auto Power Off for Scale Indicator. BALZER FIELD FLOATER 6

WEIGH SYSTEM PROGRAMMING

Scale Indicator Programming (Continued)

Set Auto Power Off for Scale Indicator

To set the scale indicator’s Auto Power Off see “Set Auto Power Off for Host Indicator” on Page 66 in Host Indicator

Programming

Set Hold Enable for Scale Indicator

To set the scale indicator’s Hold Enable see “Set Hold Enable for Host Indicator” on Page 66 in Host Indicator Programming

Set RS232 Port Baud Rate

To set the scale indicator’s RS232 Port Baud Rate see “Set RS232 Port Baud Rate” on Page 67 in Host Indicator Programming

Calibration Menu System

The following options are accessible through the calibration menu system:

Display Function Definition

Calibration Step Code Default is 000 This continues through the main calibration menu There are no user serviceable Calibration Sub menus

Radio Enable Allows the host indicator to communication wirelessly with other compatible equipment and devices

Radio Channel Sets the radio channel when the radio is enabled There are 12 radio channels available

Radio Network ID Sets the radio’s network identification (0-65534) for the radio channel being used

Radio Encryption

Enable and Key

Restore Radio

Defaults

Turning on the radio encryption makes the transmitted signal unable to be decoded without the receiver having the same encryption key (encryption key value range: 0-65534) NOTE: IF YOU FORGET THE ENCRYPTION

KEY VALUE, YOU WILL NOT BE ABLE TO CONNECT A RECEIVING

DEVICE

Default is 0 This leaves the radio settings as they have been programmed

Entering 3 will restore the radio settings to their default values

Unit Switch Enable Allows the changing of weighing units from pounds (lbs) to kilograms (kg) through the main menu

Auto Zero Tracking Automatic adjustment to the scale should the zero reading drift from the set zero of the scale

Graduation Size Set weighing incremental count Available increments: 1, 2, 5, 10, 20, 50, and 100 units (lbs or kg)

Set Radio Enable

To set the scale indicator’s Radio Enable see “Set Radio Enable” on Page 68 in Host Indicator Programming

Set Radio Channel

To set the scale indicator’s Radio Channel see “Set Radio Channel” on Page 68 in Host Indicator Programming

Set Radio Channel Network ID

To set the scale indicator’s Radio Channel Network ID see “Set Radio Channel Network ID” on Page 69 in Host Indicator

Programming

72 Field Floater 6 Grain Cart User Manual