IMPORTANT SAFETY INSTRUCTIONS
WARNING!
Read and understand all instructions before using this product. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury.
Do not use without guard and handle in place.
the wall outlet, reverse the plug. If the plug still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or extension cord plug in any way.
READ ALL INSTRUCTIONS
before using this product. Follow all safety instructions.
Failure to follow all safety instructions listed below, can result in serious personal injury.
unit.
such as rocks, broken glass, nails, wire, or string which can be thrown or become entangled in any part of the machine.
comply with ANSI Z87.1. Following this rule will reduce the risk of serious personal injury.
Use Safety Glasses – Always use face or dust mask if operation is dusty.
Dress Properly – Use rubber gloves and substantial footwear is recommended when working outdoors. Wear heavy long pants, long sleeves, boots, and gloves. Do not wear loose-fitting clothing, short pants, sandals or similar lightweight footwear, jewelry of any kind, or go barefoot.
Use of footwear and gloves with electrical protection is recommended. Footwear should protect feet and improve footing on slippery surfaces.
entanglement in moving parts.
pets at least 50 ft. away.
ill, or under the influence of alcohol, drugs, or medication.
radiators, ranges, and refrigerators. There is an increased risk of electric shock if your body is grounded.
tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock.
outdoor extension cords marked W-A, W, SW-A, SOW-A,
STW-A, STOW-A, SJW-A, SJTW-A, or SJTOW-A. These cords are rated for outdoor use and reduce the risk of electric shock.
be provided on the circuit(s) or outlet(s) to be used for the gardening appliance. Receptacles are available having built-in GFCI protection and may be used for this measure of safety. except that for which it is intended. Use the correct tool for your application.
on a solid surface enables better control of the unit in unexpected situations.
Overreaching can result in loss of balance.
Avoid Unintentional Starting – Do not carry plugged in appliance with finger on trigger. Be sure the switch trigger is not engaged before plugging in.
Any tool that cannot be controlled with the switch trigger is dangerous and must be repaired.
source before storing, servicing, changing accessories such as cutting line. Such preventive safety measures reduce the risk of starting the tool accidentally.
such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes.
plug (one blade is wider than the other) and will require the use of a polarized extension cord. The plug will fit into a polarized extension cord only one way. If the plug does not fit fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension cord will require the use of a polarized wall outlet. This plug will fit into the polarized wall outlet only one way. If the plug does not fit fully into
3 — English accessories. Use of any other parts may create a hazard or cause product damage.
Maintain appliance with care – Replace string head if cracked, chipped, or damaged in any way. Be sure the string head is properly installed and securely fastened.
Keep cutting edge sharp and clean for best performance and to reduce the risk of injury. Follow instructions for lubricating and changing accessories. Inspect appliance cord periodically, and if damaged, have it repaired or replaced by an authorized service facility only. Inspect extension cords periodically and replace if damaged.
Keep handles dry, clean, and free from oil and grease.
Failure to do so can cause serious injury.
IMPORTANT SAFETY INSTRUCTIONS
Make sure all guards, straps, deflectors and handles are properly and securely attached.
Never use flailing devices, wire, or rope on any attachment.
Use only the manufacturer’s replacement string in the cutting head when using a string trimmer attachment.
Do not use any other cutting attachment, for example, metal wire, rope, or the like. To install any other brand of cutting head to the string trimmer can result in serious personal injury.
overheating the motor. Clean after each use.
and in good condition.
Check damaged parts – Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged must be properly repaired or replaced by an authorized service center to avoid risk of personal injury.
Maintain a firm grip on both handles while trimming. Keep string head below waist level. Never cut with the string head located over 30 in. or more above the ground.
should be stored indoors in a dry, locked place out of the reach of children. Do not allow appliance to be used as a toy. Close attention is necessary when used near children.
good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. A wire gauge size (A.W.G.) of at least 14 is recommended for an extension cord 50 feet or less in length. A cord exceeding 100 feet is not recom mended.
If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating.
extension cord or yank extension cord to disconnect unit.
Keep the cord clear of operator and obstacles at all times.
Do not expose cords to heat, oil, water, or sharp edges.
Do not handle plug with wet hands.
damaged, dropped into water, return it to service center.
when picking up or holding the appliance.
less likelihood of a risk of injury at the rate for which it was designed.
Keep both hands on handles when power is on. Do not attempt to remove cut material nor hold material to be cut when blades are moving. Make sure trimmer switch is off and power supply disconnected when clearing jammed material from blades.
trimmer.
any openings blocked, keep free of dust, lint, hair and anything that may reduce air flow.
Refer to them frequently and use them to instruct others who may use this power tool.
If you loan someone this power tool, loan them these instructions also.
ADDITIONAL SPECIFIC SAFETY RULES CAN BE FOUND IN THE
APPLICABLE ATTACHMENT’S OPERATOR’S MANUAL
4 — English
