OPERATION
WARNING:
Always hold the power head away from the body keeping clearance between the body and the product. Any contact with the attachment cutting head can result in burns and/or other serious personal injury.
WARNING:
Extreme care must be taken when using a blade attachment to ensure safe operation. Read the safety information for safe operation when using a blade attachment and refer to the safety rules and instructions in your attachment manual.
Never use a brush cutter attachment with this electric power head. Improper operation of a blade or any attachment could result in serious injury.
MAINTENANCE
WARNING:
Before inspecting, cleaning or servicing the unit, stop the motor, wait for all moving parts to stop, and disconnect from power supply. Failure to follow these instructions can result in serious personal injury or property damage.
WARNING:
Always wear eye protection with side shields marked to comply with ANSI Z87.1. Hearing and/or head protection may also be required depending on the type of attachment used and as prescribed in the attachment’s
Operator’s Manual. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause product damage.
NOTICE:
Before each use, inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or damaged parts are replaced. Please contact customer service or a qualified service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, lubricant, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating lubricants, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.
CLEANING THE POWER HEAD
Stop the motor and disconnect from power supply.
Clean dirt and debris from the power head using a damp cloth with a mild detergent.
NOTE : Do not use any strong detergents on the plastic housing or the handle. They can be damaged by certain aromatic oils such as pine and lemon, and by solvents such as kerosene.
STORING THE POWER HEAD
Clean all foreign material from the product.
Store it in a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden chemicals and de-icing salts.
TROUBLESHOOTING
PROBLEM
Motor fails to start when switch trigger is depressed.
POSSIBLE CAUSE
Power cord is not plugged in or connection is loose.
Household circuit breaker is tripped.
10 — English
SOLUTION
Plug in the power cord.
Check circuit breaker.
