Using the USB memory. Panasonic PT-FRQ60BU7, PT-FRQ60WU7

Add to my manuals
221 Pages

advertisement

Using the USB memory. Panasonic PT-FRQ60BU7, PT-FRQ60WU7 | Manualzz

Chapter 3   Basic Operations — Using the USB memory

Using the USB memory

This projector supports the attachment of the USB memory. Attach the USB memory to the <USB (DC OUT)> terminal when using the data cloning function, the firmware update function, etc.

Note f

For the data cloning function, refer to the [PROJECTOR SETUP] menu → [DATA CLONING] ( x

page 124).

f

For the firmware update function, refer to the [PROJECTOR SETUP] menu → [FIRMWARE UPDATE] ( x

page 128).

Notes on use

Observe following.

f

Do not disassemble or modify the USB memory.

f

Do not apply strong impact on the USB memory.

f

Do not pour liquid such as water or get it wet.

f

Do not place foreign object into the terminal section.

f

Do not touch the metal terminal with hand or metal.

f Do not leave the USB memory in a place with high humidity or dust.

f Do not leave the USB memory in a place where static electricity or electromagnetic radiation is generated.

f

Store the USB memory appropriately in a location that small children cannot reach.

f

Immediately remove the USB memory from the projector when smoke or odor is noticed, and contact the manufacturer.

f

Do not remove the USB memory from the projector while reading or writing the data.

USB memory that can be used with the projector

This projector supports the commercially available USB 2.0 compatible USB memory formatted in FAT16 or

FAT32.

f

Only the single partition structure is supported.

Attaching the USB memory

1) Insert the USB memory all the way in to the <USB (DC OUT)> terminal.

Attention f

Take care of the orientation of the terminal when inserting the USB memory so that it will not get damaged.

f

Do not use a USB extension cable or a USB hub, and directly insert the USB memory into the <USB (DC OUT)> terminal of the projector.

Note f

The USB memory can be attached even when the projector is turned on.

Removing the USB memory

1) Remove the USB memory after confirming that the indicator on the USB memory is not blinking.

Attention f

The blinking of the indicator of the USB memory attached to the projector is indicating that the projector is accessing (reading or writing) the

USB memory. Do not remove the USB memory from the projector when the indicator is blinking.

f

The access status to the USB memory cannot be confirmed when a USB memory without the monitoring function such as indicator is used.

In such case, remove the USB memory after waiting for one of the following.

g

Turn off the projector.

g

When using the data cloning function, confirm that the saving or loading of the data to/from the USB memory is completed in the menu screen.

g

When using the firmware update function, wait until the projector automatically goes into standby after the update has started.

ENGLISH - 55

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents