Placement for Use. Hearth And Home Airo+UV

Add to My manuals
12 Pages

advertisement

Placement for Use. Hearth And Home Airo+UV | Manualzz

Placement for Use

1 . Do not place the

3-in-1 air sanitizer near curtains to avoid and prevent the curtain being

2 . Place 3-in-1 air sanitizer upright when using to ensure normal running.

3 . Place 3-in-1 air sanitizer in populated area s to effectively improve the indoor air quality.

Notice: Check the filter before using. Do not use this product if the filter is damaged.

Replace filter if there are cracks or holes in the filter.

The air sanitizer is recommended for use in a single, closed room up to 165 square feet and the heating function comfortably heats up to 600 square feet.

Operation

Main Power Switch

The Main Power Switch is located on the back of the Air Sanitizer near the power cord. When the Main Power Switch is turned on there will be a prompt sound, and the red light under the O N /O FF button will be on, indicating there is power to the control panel.

O N /O FF Button

Press the O N /O FF button to switch on the air sanitizer, press again to shut off the air sanitizer.

UV Air Sanitizing

Press the UV FAN button to switch on the UV-C l amp to effectively kill bacteria in the air.

Note, the blue light behind the grille is not the UV-C wavelength. The UV-

C lamp is contained in the bottom of the product. The light behind the grille is

LED to indicate the product is in air sanitizing mode.

Press UV FAN button once and the blue LED indicator light under UV comes on and the display shows U1 (low fan speed), press the UV FAN button a second time and the display shows U2 (high fan speed).

Fan Only

Press UV FAN button a three times and the blue LED indicator light under FAN comes on or press the FAN button on the remote and the display shows F 1 (low fan speed), press the UV FAN button a fourth time or the FAN button a second time on the remote and the display shows F 2 (high fan speed).

Press UV FAN button a fifth time to shut off the fan.

6 UV Air Sanitizer User Manual

Operation (cont.)

Shut Off Timer

Press TIMER button once for each hour increment between 1 to 12 hours to set the countdown timer to shut off either the UV and/or Heating function. The display will show the hour(s) selected. An amber LED light will indicate the timer function has been set.

Heating

Press HEAT button once and a red LED indicator light comes on and the display shows H 1 for Low Heat ( Note: High fan speed is default ), press the HEAT button a second time and the display shows H 2 for Maximum Heat .

Note: When the heater is on, t he LED light behind the grille will be red to indicate the product is in heating mode.

If the UV function is on at the same time as heating, the LED light behind the grille will be purple.

Setting Temperature

The heater temperature can be set between 60°F to 90°F (16°C to 32°C). The temperature display can be changed between °F and °C by pressing the TEMP+ and TEMP- at the same time for 3 seconds.

Press TEMP+ to increase the temperature setting and TEMP- to decrease the temperature setting.

Shut Off Heat

Press HEAT button a third time to shut off heat.

Note, the fan will continue to run for 1 minute to dissipate the heat within the product.

There is a memory feature which will keep the previous settings when the product is turned on again.

7 UV Air Sanitizer User Manual

advertisement

Related manuals

Download PDF

advertisement