Step 6 - Install Anti-Tip Bracket. Ancona AN-2330SS, AN-2348SSRD, AN-2336SSRD, AN2336SSRD, AN-2348SSWHT, AN-2348SSBK, AN-2330SSRD, AN-2330SSWHT, AN-2330SSBK, AN-2336SS

Add to my manuals
32 Pages

advertisement

Step 6 - Install Anti-Tip Bracket. Ancona AN-2330SS, AN-2348SSRD, AN-2336SSRD, AN2336SSRD, AN-2348SSWHT, AN-2348SSBK, AN-2330SSRD, AN-2330SSWHT, AN-2330SSBK, AN-2336SS | Manualzz

Installation

STEP 6

Install Anti-Tip Bracket

To reduce the risk of tipping of the range, the range must be secured to the floor with a properly installed Anti-Tip Bracket

(included).

All ranges can tip and cause injuries. Install anti-tip device packaged with range, follow all Installation Instructions.

Failure to install the Anti-Tip Bracket will allow the range to tip over if excessive weight is placed on an open door or if a child climbs upon it. Serious injury might result from spilled hot liquids or from the range itself. If range is ever moved to a different location, the Anti-Tip Bracket must be re-installed.

Make sure the anti-tip bracket is installed: u Slide range forward.

v Make sure the anti-tip bracket is securely attached to the wall behind the range.

w Safely tilt the front of the range upward slightly and move back against wall, Making sure the pin slides under bracket.

Figure 12

STEP 7

Connect to AC

DANGER:

• Please make sure to read ALL safety precautions on pages 4 to 10.

• Electrical Shock Hazard.

• Do not use an adapter.

• Do not use an extension cord.

• Failure to follow these instructions can result in death, fire, or electrical shock.

• Electrical connection must be performed by a qualified service technician in accordance with the kit instructions and all local codes and requirements.

• The safety circuit-breaker and the electrical system must be able to withstand the load of the appliance. See rating label on back of appliance.

• Rating plate is located on back of appliance should you need to verify any of the electrical requirements.

• The power supply system should have a ground connection in good working order in accordance with the regulations in force.

• The electrical socket must be easily accessible with the appliance installed. In all cases, the power supply lead must be positioned so that it does not reach a temperature of 50°C (122°F) above the room temperature at any point.

• The manufacturer is not liable for any direct or indirect damage caused by faulty installation or connection. It is therefore necessary that all installation and connection operations are carried out by qualified personnel, complying with the local and general regulations in force.

— 19 —

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals