Overload protections on the machine. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

Overload protections on the machine. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

3.2

3.3

Machine Description

Overload protections on the machine

Overload protections on the machine

NOTICE

Machine damage due to load peaks

The overload protections protect the tractor and the machine from load peaks. For this reason, overload protections must not be modified. The warranty for the machine becomes void if other than the factory-specified overload protections are used.

„ Only use the overload protections installed in the machine.

„ To avoid early wear of the overload protection, switch the PTO shaft off if the overload protection responds for a longer period of time.

„

„Shut down and safeguard the machine, see Page 24

.

3

3.2

Universal shaft

A friction disc clutch on the universal shaft protects against overload. The friction disc clutch is set at the factory. Never change the adjustment without consulting your KRONE service partner.

To vent the friction clutch, see Page 113 .

Labelling

INFO

The entire identification plate represents a legal document and should not be altered or rendered illegible!

Type plate

KMG000-021

I For "Pushed" version II For "Trailed" version

The machine data are specified on the type plate (1). The type plate is mounted on the face side on right on the housing.

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB 47

advertisement

Related manuals

advertisement

Table of contents