universal shaft. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

universal shaft. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

6

6.2

6.2

Commissioning universal shaft

universal shaft

6.2.1

Adapting universal shaft

NOTICE

Changing the tractor

There is a risk of damaging the machine if the length of the universal shaft is not checked when the tractor is changed.

„ To prevent damage to the machine, check the length of the universal shaft whenever you change tractors. Have it corrected by a KRONE service partner if necessary.

The ends of the enclosed universal shaft are equipped with a longer and a shorter guard over the joints. The joint with the longer guard must be pushed towards the machine onto the drive shaft.

KMG000-047

ü The machine is connected to the tractor,

see Page 64 .

„

Shut down and safeguard the machine, see Page 24

.

„ Disassemble the universal shaft.

„ Install one of the two halves (1, 2) on the tractor side and one on the machine side.

„ Shorten profile tubes and guard tubes as specified in the operating instructions of the universal shaft manufacturer.

„ Check the overlapping of profile tubes and guard tubes.

54

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB

advertisement

Related manuals

advertisement

Table of contents