Mounting lower link extension. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

Mounting lower link extension. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

7

7.5

7.5

Start-up

Mounting lower link extension

Mounting lower link extension

3

8 9 10 11

2

7

5

6

I

6 4

4

1

KMG000-114

The lower link extensions are used as an extension of the lower links to increase the distance between the machine and the front wheels of the tractor.

INFO

The accessories kit “Lower Link Extension” can be ordered by stating the order number

20 035 793 *.

ü The machine is disconnected from the tractor.

„ Dismount the installed lower link pin (1), the linch pin (2) and the safety chain (3), right and left side.

„ Detail (I): Drive the roll pin (6) into the larger diameter of the bolt (4) provided.

„ Insert the lower link extension (5) into the opening of the three-point hitch.

„ Push the preassembled bolt (4) from the inside through the three-point hitch and through the lower link extension.

Ensure that the roll pin (6) sits in the groove of the three-point hitch.

„ To secure the bolt (4), drive the roll pin (7) through the bolt.

„ Screw the lower link extension with disc (8), sleeve (9), disc (10) and screw (11) on the three-point hitch.

The thicker disc sits between the lower link extension and the sleeve.

„ Mount the safety chain (3) on the lower link extension (5).

„ Push the lower link pin (1) through the lower link extension and secure it with the linch pin (2), right and left side.

7.6

Checking/setting parallel lifting

NOTICE

If the machine does not lift in parallel with to the ground, the machine or the tractor may be damaged.

If the machine does not lift in parallel with the ground, the universal shaft may bend unfavourably. If the universal shaft is bent unfavourably, the machine will not run smoothly.

This may damage the machine or the tractor seriously.

„ To prevent damage, the machine must be aligned in parallel with the ground when it is lifted.

„ Whenever mounting the machine again, check the parallelism of the machine to the ground when it is lifted.

66

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB

advertisement

Related manuals

advertisement

Table of contents