7
7.8
Start-up
Connecting hydraulic hoses
Hooking the supporting chain into the next-longer link
Lift the machine into the transport position via the front hydraulics.
Shut down and safeguard the machine, see Page 24
.
For mounting with turnbuckle: Hook the chain (3) into the turnbuckle by the next-longer chain link.
For mounting without turnbuckle: Hook the chain (3) into the top link fork (4) by the nextlonger chain link.
Repeat the process until the internal chains (2) no longer tension when the machine is in the working position.
7.8
Connecting hydraulic hoses
WARNING
Risk of injury from escaping hydraulic oil
The hydraulic system operates at very high pressure. Escaping hydraulic oil may seriously injure skin, limbs and eyes.
Prior to connecting the hydraulic hoses to the tractor, depressurise both sides of the hydraulic system.
Depressurise the hydraulic system before you uncouple the hoses and work on the hydraulic system.
When connecting the quick couplings, ensure that they are clean and dry.
Check hydraulic hoses at regular intervals see Page 121 and replace them if they are
damaged (e.g chafing areas or points of contact) or aged. The replacement lines must comply with the technical requirements of the device manufacturer.
NOTICE
Damage to the machine due to soiling of the hydraulic system
If foreign objects or liquids get into the hydraulic system, the hydraulic system may be severely damaged.
When connecting the quick couplings, ensure that they are clean and dry.
Check the hydraulic hoses for abrasion and pinch point and replace if required.
70
KMG000-076
In order to connect the hydraulic hoses properly, the hydraulic hoses (1, 2) are marked with numbers or letters.
Hydraulic hoses for connection to a single-acting control unit are marked with a number and the plus sign, e.g. (1+).
EasyCut F 320 CV
Original operating instructions 150000173_09_en-GB
