Checking locking device and latch. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

Checking locking device and latch. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

7 Start-up

7.14

Checking locking device and latch

7.14

Checking locking device and latch

7.15

KM000-267

ü

The machine is in the working position, see Page 85 .

ü

The machine is shut down and safeguarded, see Page 24

.

On right-hand and left-hand machine side:

„ Check that locking device/latch (1) is tight.

„ Tighten the locking device/latch (1).

„ Check the locking device/latch (1) for damage and ageing.

„ Replace damaged and porous locking devices/latches (1).

INFO

Locking devices/latches (1) can be ordered by stating the order number 00 250 831 *.

Checking the tines on the tine conditioner

NOTICE

Loss of tines

Bent and broken tines will cause an imbalance. Therefore the machine may be damaged.

„ Check the tine conditioner for bent and damaged tines each time before it is used.

„ Replace bent or damaged tines before starting work.

„ To prevent a loss of tines, check the bearing journals of the tine bearings and replace them in time.

76

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB

advertisement

Related manuals

advertisement

Table of contents