Driving and Transport. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

Driving and Transport. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

9

Driving and Transport

Preparing the machine for road travel

9

9.1

Driving and Transport

WARNING

Risk of injury due to non-observance of relevant safety notices

If the relevant safety notices are not observed, persons may get seriously injured or killed.

„

To avoid accidents, the basic safety instructions must be read and observed, see

Page 13 .

WARNING

Risk of injury due to non-observance of safety instructions

If the relevant safety routines are not observed, persons may be seriously injured or killed.

„ The safety routines must be read and observed to avoid accidents,

see Page 24 .

WARNING

Risk of accident caused by non-locked regulating valves of tractor

When regulating valves are not locked, machine components could be activated unintentionally. This may result in serious accidents.

„ To avoid that functions are triggered by mistake, the regulating valves of the tractor must be in neutral position when performing transport journeys on the road and must be locked.

WARNING

Risk of accident from open stop cocks

Machine components could be moved unintentionally when stop cocks are open. This may result in serious accidents.

„ In order to avoid that functions are triggered by mistake, the stop cock/s must be closed during transport/road travel.

NOTICE

When attaching implements at the front and rear, the permitted total weight, the permitted axle loads and the tyre load capacity of the tractor must not be exceeded. Even with an implement mounted at the rear, the front axle of the tractor must always be loaded with at least 20% of the tare weight of the tractor.

„ Prior to starting the trip, ensure that these conditions are met,

see Page 60 .

9.1

Preparing the machine for road travel

ü

All items listed in chapter "Start-up" have been fulfilled, see Page 60 .

ü

The machine has been shut down and secured, see Page 24

.

ü The hydraulic hoses are connected,

see Page 70 .

ü

The universal shaft is mounted, see Page 74 .

ü

The front guard is closed and locked, see Page 79

.

ü

The side guards are folded up, see Page 81 .

ü

The support jack is in the transport position, see Page 83

.

ü For the "Camera Monitor System" version: The camera monitor system is connected, switched on, functioning and the cameras have been cleaned.

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB 89

advertisement

Related manuals

advertisement

Table of contents