9
9.2
Driving and Transport
Parking the machine
The assistance system in the "Camera Monitor System" does not exempt the driver from responsibility for ensuring the safe operation of the machine on the road (StVO - Road
Traffic Act).
ü
The machine is in the transport position, see Page 86
.
ü The front hydraulics of the tractor are locked, e.g. via a stop cock.
ü
The stop cocks on the hydraulic hose lines are closed, see Page 84
.
ü The control units on the tractor are in neutral position and locked.
ü The guard cloths of the side guards are laid inwards.
ü Depending on the national regulations:
The lighting is connected and functional, see
Page 71 .
ü Depending on the national regulations:
The lost load centre has been checked, see
Page 75 .
ü Soiling and crop residue have been removed from the machine, in particular from the lighting and identification elements.
ü Ground clearance is sufficient.
ü
The permitted weights of the machine are observed, see Page 49
.
9.2
Parking the machine
For the “pushed” version
6
1
7
2
5
3
4
7 2
KMG000-019
90
EasyCut F 320 CV
Original operating instructions 150000173_09_en-GB
Driving and Transport
Parking the machine
9
9.2
WARNING
Risk of injury when removing the supporting chains
In the working position the retaining chains are subject to high drawing tension. In case an attempt is made to remove or adjust the supporting chain when the machine is in the working position, people may be seriously injured or killed.
The supporting chains must only be removed or set when the machine is in the transport position.
Lift the machine into transport position,
see Page 86 .
Shut down and safeguard the machine, see Page 24
.
Remove the supporting chains (2) of the spring relief from the tractor side.
Lower the support jack (1) and secure it with the bolt,
see Page 84
.
Lower the machine,
see Page 86
.
For the “hydraulically folding side guards” version: Depressurise the tractor hydraulics.
Shut down and safeguard the machine, see Page 24
.
Loosen the guard cloth (4).
Remove the supporting chain (5) of the universal shaft on the tractor side.
Remove the universal shaft (6) from the tractor side and place it on the universal shaft bracket (7).
For version with "Lighting": Pull the 7-pin plug of the connection cable out of the 7-pin socket of the tractor and place it on the machine.
Uncouple the hydraulic hose(s) (2) from the tractor, mount the dust cap(s) and put them on the machine.
Detach the top link (3).
Unlock the lower link hooks of the tractor.
Continue to lower the front lifting device until the lower link pins are free.
Carefully drive away by reversing the tractor.
EasyCut F 320 CV
Original operating instructions 150000173_09_en-GB 91
