Adjusting the relief spring(s). Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

Adjusting the relief spring(s). Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

10.3

Settings 10

Adjusting the relief spring(s) 10.3

ð Top link shorter = greater cutting height

„ Tighten the counter nuts (2,3).

Adjusting the relief spring(s)

For the “pushed” version

WARNING

Risk of injury due to adjustment of relief spring(s)

In the working position the relief spring(s) are subject to high drawing tension. In case an attempt is made to remove or adjust the relief spring(s) when the machine is in the working position, people may be seriously injured or killed.

„ The relief spring(s) must only be dismounted or adjusted in the transport position.

„ The bottom fittings on the relief spring(s) are fully screwed in.

1

+

2

KMG000-039

The relief springs (1) are used to adjust the ground pressure of the cutterbar to the local conditions. To protect the sward, the load on the cutterbar must be relieved so that it does not jump during mowing and does not leave any brush marks on the ground either.

The ground pressure of the mower can be adjusted at the perforated bar, the length of the supporting chain and (when using the turnbuckle) at the turnbuckle.

Increasing/reducing ground pressure via perforated bars

KM000-376

Borehole (I) = maximum mower relief = minimum ground pressure

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB 97

10 Settings

10.3

Adjusting the relief spring(s)

Borehole (VI) =minimum mower relief = maximum ground pressure

ü The machine is in the transport position.

ü

The machine is shut down and safeguarded, see Page 24

.

„ Attach the relief spring (1) in one of the boreholes (I) to (VI).

Attach the relief springs identically on both sides.

Increasing/reducing ground pressure via supporting chains

KM000-377

I) With turnbuckle II) Without turnbuckle

Supporting chain short = high mower relief = low ground pressure

Supporting chain long = low mower relief = high ground pressure

ü The machine is in the transport position.

ü

The machine is shut down and safeguarded, see Page 24

.

„ To increase the ground pressure, extend the supporting chain (1).

„ To reduce the ground pressure, shorten the supporting chain (1).

The supporting chains should have the same length on both sides.

Increasing/reducing ground pressure via turnbuckles

98

KM000-378

Reduce dimension X = increased mower relief = lower ground pressure

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB

advertisement

Related manuals

advertisement

Table of contents