10 Settings
10.5
Increasing/reducing the soil pressure - for version with “hydraulic relief adjustment”
10.5
Increasing/reducing the soil pressure - for version with “hydraulic relief adjustment”
For the “trailed” version
III I
1
KMG000-043
The hydraulic cylinder adjusts the ground pressure of the cutterbar to the local conditions. To protect the sward, the cutterbar must be relieved to such an extent that it does not jump when mowing or leave any traces of abrasion on the ground.
ü The hydraulic hose (1+) is connected to a single-acting control unit.
Move the stop cock (1) into position (I),
see Page 84 .
Actuate the control unit (1+) until the mower is lowered to working position.
Move the stop cock (1) into position (III),
see Page 84
.
Actuate the control unit (1+) until the desired relief pressure is displayed on the pressure gauge (2).
Æ The higher the relief pressure, the lower the ground pressure.
Æ The lower the relief pressure, the higher the ground pressure.
2
KMG000-116
The relief pressure can be read off on the pressure gauge (2). Set the ground pressure according to the ground conditions.
Recommended relief pressure: 80...100 bar .
100
EasyCut F 320 CV
Original operating instructions 150000173_09_en-GB
