Setting wide spreading. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

Setting wide spreading. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

10 Settings

10.10 Setting wide spreading

10.10

Setting wide spreading

KM000-279

ü

The machine is shut down and safeguarded, see Page 24

.

Mounting deflector sheets

„ Dismount the swath flaps (1), place them on the machine and secure with the bolts (11) and spring cotter pins (10).

„ In the front part of the deflector sheet (2), insert the coach screw (3) M10x25 from below and tighten it from above with a plastic disc (4), a disc (5) and a palm knob (6).

„ Ensure that the palm knobs are screwed down as tightly as possible, as they can easily get lost due to vibrations.

„ In the rear part of the deflector sheet (2), insert the coach screw (7) M8x20 from below and tighten it from above with a disc (8) and a locknut (9).

Depending on the operating conditions, the deflector sheets (2) may have to be readjusted to ensure equal distribution across the entire area.

10.11

Configure/check the Camera Monitor System

The defined field of view is composed of the direct field of view (6) and the camera field of view (5). The camera-monitor system must be adjusted so that points (1) to (4) are visible on the monitor on the left and right sides respectively.

104

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB

4 5 2 6

Settings 10

Configure/check the Camera Monitor System 10.11

6 2 5 4

3 1 1 3

KM001-349

ü

The camera-monitor system has been connected, see Page 73

.

„

Shut down and safeguard the machine, see Page 24

.

„ Switch on the ignition.

„ Switch the monitor on, see the monitor manufacturer's instructions.

„ Call up the divided display mode, see the monitor manufacturer's instructions.

„ Ensure that the cameras are properly connected to the monitor.

Æ The cameras are properly connected if the right-hand side of the divided display shows the picture from the right camera and the left-hand side that from the left camera.

Æ The cameras are not properly connected if the right-hand side of the divided display shows the picture from the left camera and the left-hand side that from the right camera. If the display sides are reversed, change the plugs (CAM1/CAM2),

see Page 73 .

EasyCut F 320/360 CV/CR trailed

7 8 8 7

9

9

KM000-476

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB 105

10 Settings

10.11 Configure/check the Camera Monitor System

EasyCut F 320/360 CV/CR pushed

7 8

9

KM001-350

„ Loosen the screws (8) and (9) and adjust the cameras (7) so that points (1) to (4) are visible on the monitor on the left and right sides respectively.

„ Tighten the screws (8) and (9).

106

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB

advertisement

Related manuals

advertisement

Table of contents