11.7.2
Maintenance - General Information 11
Drive belt 11.7
Tensioning/relieving belt drive
ü
The machine is shut down and safeguarded, see Page 24
.
ü
The guard is dismounted, see Page 116 .
Relieving belt drive
KM000-381
Pull out the linch pin (1).
WARNING! Risk of injury! While relieving the belt drive, the blade key (2) is under spring tension. If the blade key is released too early, it will spring back. While relieving, do not release the blade key.
To relieve the belt drive, insert the blade key (2) in the tensioning device (3) and pull it towards the rear.
Tensioning belt drive
KM000-382
WARNING! Risk of injury! While relieving the belt drive, the blade key (2) is under spring tension. If the blade key is released too early, it will spring back. While relieving, do not release the blade key.
Slide the blade key (2) into the tensioning device (3).
To tension the belt drive, push the blade wrench forward until the tensioning device engages.
To secure the tensioning device, insert the linch pin (1) into the borehole.
Check the belt tension,
see Page 118
.
Mount the guard, see Page 116
.
EasyCut F 320 CV
Original operating instructions 150000173_09_en-GB 117
