Checking/setting belt tension. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

Checking/setting belt tension. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

11 Maintenance - General Information

11.7

Drive belt

11.7.3

Checking/setting belt tension

KM000-383

If the belt drive is tensioned, the display (1) must be closed off flush with the upper edge of the compression spring (2).

ü

The machine is shut down and safeguarded, see Page 24

.

ü

The guard is dismounted, see Page 116 .

ü

The belt drive is tensioned, see Page 117 .

„ Check whether the display (1) ends flush with the upper edge of the compression spring (2).

If the display (1) ends flush with the upper edge of the compression spring (2), the belt tension is correct.

If the display (1) does not end flush with the upper edge of the compression spring (2), the belt tension must be adjusted.

„ Detension the belt drive,

see Page 117

.

„ Loosen the nut (4).

When the display is above the compression spring:

„ Unscrew the sleeve (3) further (turn counterclockwise).

When the display is under the compression spring:

„ Screw the sleeve (3) in further (turn clockwise).

„ Tighten the nut (4).

„ Tension the belt drive,

see Page 117

.

„ Repeat the process until the display (1) ends flush with the upper edge of the compression spring (2) with the belt drive tensioned.

„ Mount the guard (5) of the belt drive,

see Page 116

.

118

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB

advertisement

Related manuals

advertisement

Table of contents