Maintenance - Gearbox 13
Input gearbox 13.2
13.2
Input gearbox
For the “pushed” version
4
1
3
5
2
KM000-391
Comply with the safety routine "Safe execution of oil level check, oil and filter element exchange",
see Page 25 .
INFO
The oil level must be checked and the oil must be changed in working position and with machine in horizontal position.
Loosen the supporting chain(s) (5).
Remove the intermediate universal shaft(s) from the input gearbox.
Dismount the guard (4).
Checking the oil level
NOTE! Risk of machine damage due to improperly performed oil level check, oil and filter element change! Follow the safety routine "Oil level check. Changing oil and filter elements safely",
see Page 25
.
Remove the locking screw from the inspection hole (1).
ð If the oil reaches the inspection hole (1):
Mount the locking screw of the inspection hole (1); tightening torque
see Page 112
.
ð If the oil does not reach the inspection hole (1):
Remove the locking screw from the filling hole (3).
Refill with fresh oil up to the inspection hole (1) via the filling hole (3).
Screw the locking screw into the inspection hole (1) and the locking screw into the filling
hole (3), tightening torque see Page 112 .
Mount the guard (4).
Slide the intermediate universal shaft(s) onto the input gearbox and secure it/them.
Secure the universal shaft guard(s) with the supporting chain(s) (5) against turning.
Changing the oil
ü A suitable container is available for escaping oil.
EasyCut F 320 CV
Original operating instructions 150000173_09_en-GB 123
13 Maintenance - Gearbox
13.2
Input gearbox
NOTE! Risk of machine damage due to improperly performed oil level check, oil and filter element change! Follow the safety routine "Oil level check. Changing oil and filter elements safely",
see Page 25
.
Loosen the supporting chain(s) (5).
Remove the intermediate universal shaft(s) from the input gearbox.
Dismount the guard (4).
Unscrew the locking screw of the inspection hole (1) and the locking screw of the filling hole (3).
Unscrew the drain plug (2) and drain the oil.
Mount the drain plug (2), tightening torque see Page 112
.
Top up with fresh oil via the filling hole (3) up to the inspection hole (1).
Screw the locking screw into the inspection hole (1) and the locking screw into the filling
hole (3), tightening torque see Page 112 .
Mount the guard (4).
Slide the intermediate universal shaft(s) onto the input gearbox and secure it/them.
Secure the universal shaft guard(s) with the supporting chain(s) (5) against turning.
Mount the guard (4).
Slide the intermediate universal shaft(s) onto the input gearbox and secure it/them.
Secure the universal shaft guard(s) with the supporting chain(s) (5) against turning.
For the “trailed” version
1 3
124
2
KM000-392
INFO
The oil level must be checked and the oil must be changed in working position and with machine in horizontal position.
ü
The machine is shut down and safeguarded, see Page 24
.
Checking the oil level
NOTE! Risk of machine damage due to improperly performed oil level check, oil and filter element change! Follow the safety routine "Oil level check. Changing oil and filter elements safely",
see Page 25
.
Remove the locking screw from the inspection hole (1).
ð If the oil reaches the inspection hole (1):
Mount the locking screw of the inspection hole (1); tightening torque
see Page 112
.
EasyCut F 320 CV
Original operating instructions 150000173_09_en-GB
