Replacing the shear bolt at the rotary hub. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

Replacing the shear bolt at the rotary hub. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

14.2

7

8

Maintenance - Cutterbar 14

Replacing the shear bolt at the rotary hub 14.2

Replacing the shear bolt at the rotary hub

NOTICE

Wrong installation position

The machine may be damaged if the installation position of the bearing housings is not observed.

„ Clockwise rotating (RH) cutting discs / mower drums always have right-handed pinion shaft and nut (no groove mark on pinion shaft and nut).

„ Anti-clockwise rotating (LH) cutting discs / mower drums always have left-handed pinion shaft and nut (with groove mark on pinion shaft and nut).

I a

9

10

2 3

3

3a

3 1

3a

!

3a

4 d b

C

KM000-049_1

ü The machine is in the working position.

ü

The machine has been shut down and secured, see Page 24

.

„ Dismount the cutting disc or the mower drum at the rotary hub with the defective cutterbar protection system.

„ Remove the retaining ring (7).

„ Unscrew the screws (8). If detent edged washers (9) are present, remove the detent edged washers (9).

„ Use the special spanner (10) included with delivery to unscrew the nut (2).

„ Dismount the hub (1).

„ Remove the damaged shear pins (3) from hub (1) and shaft (4).

„ Check the nut (2) and the hub (1) for damage.

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB 129

advertisement

Related manuals

advertisement

Table of contents