Checking impact stops on the cutterbar. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

Checking impact stops on the cutterbar. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

14.6

Maintenance - Cutterbar 14

Checking impact stops on the cutterbar 14.6

WARNING! Risk of injury due to sharp blades! When inserting the blades, wear suitable protective gloves.

„ Insert the blades (5).

„

Fold down the front guard, see Page 79

.

Checking impact stops on the cutterbar

NOTICE

Irregular check of the impact stops

The impact stops are subject to natural wear. They must be checked daily for wear, and be replaced if necessary. The machine can be damaged if checks are not performed.

„ Have the impact stops replaced by authorised specialists only.

1

2

14.7

KM000-081

ü

The machine is in the working position, see Page 85 .

ü

The machine has been shut down and secured, see Page 24

.

„

Fold up the front guard, see Page 79

.

The impact stops (1) must be checked daily for wear. If required, the impact stops (1) must be replaced by authorised specialists.

„ Have the impact stops (1) replaced by authorised specialists if the impact stops (1) show signs of wear.

„ Have the impact stops (1) replaced by authorised specialists if the weld seam (2) is no longer fully visible due to abrasion.

„

Fold down the front guard, see Page 79

.

Check/replace cutting discs/mower drums

WARNING

Risk of injury from damaged cutting discs/mower drums.

If cutting discs/mower drums are damaged, blades may become detached due to high rotating speed. This can be the reason for serious or fatal injuries.

„ The cutting disks/mower drums must be checked at least once a day or after contact with foreign objects.

„ Check/replace damaged cutting discs/mower drums.

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB 139

14 Maintenance - Cutterbar

14.7

Check/replace cutting discs/mower drums

140

KM000-042

The cutting discs/mower drums must not exceed the dimension X=48 mm . If there are cracks, notches or holes, the cutting discs/mower drums must always be replaced.

Checking the wear limit on the cutting discs/mower drums

WARNING

Risk of injury from worn cutting discs/mower drums.

Due to worn cutting discs/mower drums, the blades or parts may loosen because of high rotating speed. This can be the reason for serious or fatal injuries.

„ Check/replace the cutting discs/mower drums.

3 3

2 1

4

KM000-043

ü

The machine is in the working position, see Page 85 .

ü

The machine has been shut down and secured, see Page 24

.

„

Fold up the front guard, see Page 79

.

The wear limit for material abrasion (2) on the cutting discs (3) / mower drums (4) is reached when the material thickness at any point on the cutting discs (3) / mower drums (4) is less than

3 mm .

„ Use callipers (1) to measure the material thickness at the cutting discs (3) / mower drums (4).

„ Replace the cutting discs (3) / mower drums (4) at the latest when the minimum material thickness of 3 mm is not reached at any point on the cutting discs (3) / mower drums (4).

„

Fold down the front guard, see Page 79

.

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB

advertisement

Related manuals

advertisement

Table of contents