Checking oil level. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges.

Add to My manuals
154 Pages

advertisement

Checking oil level. Krone BA EasyCut F 320 CV, BA EasyCut F 320 CV gez./ges. | Manualzz

Replacing cutting discs/mower drums

1 1

1

3

3

Maintenance - Cutterbar 14

Checking oil level 14.8

1

14.8

4

5

5

KM001-429

ü

The machine is in the working position, see Page 85 .

ü

The machine has been shut down and secured, see Page 24

.

„

Fold up the front guard, see Page 79

.

To replace the cutting discs (3) / mower drums (4), proceed as follows:

WARNING! Risk of injury due to sharp blades! When removing the blades, wear suitable protective gloves.

„ Remove the blades (5).

„ Dismount the screws (1).

„ Remove and replace the cutting disc (3) / mower drum (4).

WARNING! Observe the installation position of the cutting discs/mower drums,

see

Page 128

.

„ Mount and tighten the screws (1).

WARNING! Risk of injury due to sharp blades! When inserting the blades, wear suitable protective gloves.

„ Insert the blades (5).

„

Fold down the front guard, see Page 79

.

Checking oil level

INFO

There is no need to change the oil on the cutterbar.

Before checking the oil level on the cutterbar, level the cutterbar using a spirit level.

KM000-284

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB 141

14 Maintenance - Cutterbar

14.8

Checking oil level

NOTE! Risk of machine damage due to improperly performed oil level check, oil and filter element change! Follow the safety routine "Oil level check. Changing oil and filter elements safely",

see Page 25

.

„

Shut down and safeguard the machine, see Page 24

.

Aligning the cutterbar in transverse direction (direction of travel)

„ Position the spirit level (1) transversely on the cutterbar.

„ Align the cutterbar using the spirit level (1) and readjust, if necessary, via cutting height

setting, see Page 95 .

Aligning the cutterbar in longitudinal direction

„ Position the spirit level (1) on two cutting discs.

„ Use the spirit level (1) to align the cutterbar, if necessary use wedges to align it horizontally.

Checking oil level

KM000-036

„ Release the locking screw of the inspection hole (1).

ð The oil level must reach up to the inspection hole (1).

If the oil reaches the inspection hole (1):

„

Mount the locking screw of the inspection hole (1), see Page 112

.

If the oil does not reach the inspection hole (1):

„ Top up new oil via the inspection hole (1) up to the inspection hole (1).

„

Mount the locking screw of the inspection hole (1), see Page 112

.

142

EasyCut F 320 CV

Original operating instructions 150000173_09_en-GB

advertisement

Related manuals

advertisement

Table of contents